2003 International Fuel Gas Code addresses the design and installation of fuel gas systems

The 2003 International Fuel Gas Code contains complete requirements for fuel-gas piping systems, equipment and accessories. It includes combustion air requirements, sizing tables for venting Category 1 appliances and provisions that are coordinated with the National Fuel Gas Code (ANSI Z223.1).

Table of Contents:

• Chapter 1 Administration
• Chapter 2 Definitions
• Chapter 3 General Regulations
• Chapter 4 Gas Piping Installations
• Chapter 5 Chimneys And Vents
• Chapter 6 Specific Appliances
• Chapter 7 Gaseous Hydrogen Systems
• Chapter 8 Referenced Standards
• Appendix A Sizing And Capacities Of Gas Piping (IFGS)
• Appendix B Sizing Of Venting Systems Serving Appliances
  Equipped With Draft Hoods, Category I Appliances, And
  Appliances Listed For Use And Type B Vents (IFGS)
• Appendix C Exit Terminals Of Mechanical Draft And
  Direct-Vent Venting Systems (IFGS)
• Appendix D Recommended Procedure For Safety Inspection
  Of An Existing Appliance Installation (IFGS)
• Index

Accessories:

Turbo Tabs - 2003 ICC International Fuel Gas Code - Looseleaf

Other versions of the 2003 ICC International Fuel Gas Code are available:

2003 ICC International Fuel Gas Code, PB